Corrugations allow a nearly zero bend radius - easily flexed
Can be extended or compressed without affecting
the tube's I.D.
Made without plasticizers which can leach into
Made from FDA compliant materials
Has all the chemical and electrical properties of straight-walled FEP tubing
May be overbraided with Kevlar® for higher
Chemical Processing Corrosives Deionized Water Hot Glue Laboratory Uses
Paint Spray Pure Fluid Transfer Solvent Transfer
Hardness, Shore D
Tensile Strength, psi
Elongation at Break, %
Min. Operating Temp. for Tubing^^
Max. Cont. Svc. Temp. for Tubing,
zero pressure ^^
**Values listed are typical and are
meant only as a guide to aid in design. Field testing
should be performed to find the actual values for the
^^Temperatures are for standard extruded non-corrugated
Optimal flow is achieved and turbulence
minimized by passing fluids through CORRTEF in the
direction of the corrugation angles (as noted).
CORRTEF is heat sealable, and the cuffs
(straight ends) are made to accept standard barbed
fittings. The end may be flared or expanded to permit
CORRTEF is manufactured in an industrial atmosphere and should be properly sterilized for clean-flow applications. For optimal cleaning of CORRTEF the tube should be stretched to its maximum length and held vertically (direction of flow: down). NOTE: Due to the annular corrugations, it may not be possible to remove all traces of particulate from CORRTEF, even under optimal cleaning conditions.
^Overbraiding with Kevlar® will permit a minimum increase of 6X the listed pressures. Kevlar overbraiding is available for sizes up to 7/8" I.D. call for details.
*Workable I.D. length of the cuff.
All lengths will be supplied with 'B' dimension cuffs (straight ends).
All pressures are calculated and not based on actual testing. ID is the critical dimension for fittings
Dowload a printable PDF version of our Fluoropolymer Tubing & Hose Catalog.